Underfloor heating in the Czech Republic, installed complete

Heat that comes from below and never gets in the way

Underfloor heating installed as a complete package for new builds and renovations anywhere in the Czech Republic. We design the build-up for your house and heat source, lay it, pressure test it, coordinate the screed and set up the controls. One team from the first calculation to the first heating season.

Get a free design

Freesite visit and design

24 hoursreply on working days

Nationwidevetted regional installers

Three ways to a warm floor

Hydronic underfloor heating

Pipes in the screed connected to a heat pump, boiler or heat exchanger. The most economical way to heat a whole house with low temperature water.

Best for: new builds, full renovations, houses with a heat pump.

Bathroom with tiles heated by an electric heating mat

Electric underfloor heating

Heating mats and cables under tiles or floating floors. No pipes, no screed, done in a day.

Best for: bathrooms, flats, cottages, single rooms.

Low build-up renovations

Dry systems, milled grooves in the existing screed or thin-layer boards. Underfloor heating even where height or load is limited.

Best for: older houses, apartment buildings, timber frames, lofts.

How the job runs

Site visit and heat loss

We measure, check floor heights and the heat source. Free of charge.

Design

Pipe spacing, loops, manifold, controls. You get a drawing and an itemised quote.

Installation

Insulation, system board, pipes or mats, pressure test before the screed.

Screed and test

Anhydrite or cement screed, curing, heating test with a protocol.

Controls and handover

Thermostats and zoning set up, documentation handed over.

Questions we get asked

Hydronic or electric underfloor heating?

Hydronic (water) suits whole-house heating, especially with a heat pump. Electric mats are quick to install and cheap to buy, ideal for bathrooms, single rooms and renovations where you do not want to touch the heating pipes.

How much floor height does it need?

A wet screed system typically adds several centimetres above the insulation. Dry and milled systems for renovations fit into a few centimetres, electric mats add millimetres.

Can it be combined with a heat pump?

It is the ideal pair. Underfloor heating works with low water temperatures, exactly where a heat pump is most efficient.

My existing system heats poorly. Do you fix it?

Yes. Most often the manifold is unbalanced or clogged, or there is air in the loops. We flush, bleed and balance without breaking the floor.

Send us your floor plan, we will come back with a design

A few details are enough. We reply within 24 hours on working days, arrange a free site visit and put together a design for your house and heat source. No obligation.